Product Code: SmokTech_3392
Availability: In Stock
$54.99
Ex Tax: $54.99

Available Options


HIT BY TASTE STORM

TWO EDITIONS FOR YOU

The 22mm diameter of Spirals tank compatibles with most mini mods. And the built-in large size coil 
head adopts Japan imported cotton, brand new coil and precise wicking hole. Joined by adjustable 
small size air slots and elongated drip tip, all that makes it to be a taste whirlwind that offers you 
authentic, powerful and charming taste. Yes, it is the Spirals tank that brings your impressive 
experience. 
The 24.5mm Spirals Plus Tank is bigger than Spirals tank, which is the newest great design 4ml sub 
ohm from SMOK. It offers you with more clouds and deep taste.

THE KIT INCLUDES


SPECIFICATIONS


SCHEMATIC DIAGRAM


6 COLORS FOR YOU

There are 6 colors for you, and any one of them can compatible with all mods.



BOTTOM ADJUSTABLE 

AIRFLOW SYSTEM

Spirals Tank/Spirals Plus Tank has 4 small air slots on the bottom, airflow can be adjusted freely, which 

allows you to have an extremely open draw.


BIG FAMILY OF SPIRALS 

TANK/SPIRALS PLUS TANK


DELRIN DRIP TIP

The delrin drip tip will bring increased airflow and provide you with powerful draw effects.


TOP REFILL SYSTEM

Top refill system makes filling as easy as it gets.


HOW TO BUILD THE RBA

1 . Before starting, make sure your hands are clean. 

2. Take RBA deck apart.


3. Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends 

around the screws and tighten up, once all is in place, make sure the coil is fixed in the center and 

lined up with the air hole, and also make sure the coil is NOT touching the base.

4. Cut the excess ends of the wire off.


5. Cut a strip of cotton and make sure it’s not too much and not too little.
6. Insert the cotton and placing it in the middle of the coil.
7. Cut the cotton at an angle and make sure it’s not too short and not too long.


8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked 

periodically to ensure the resistance remains the same.


[db:参数组]
[db:参数值]

Write a review

Note: HTML is not translated!